Preparation
Fig. 11 - 09
11 - 8
Fig. 11 - 10
1
3
12
11.09 Adjusting the sewing pressure
● Adjust the pressure on the work clamp
by turning the adjustment screw 1.
The sewing pressure is
dependent on the material to
be sewn and must be adjusted
accordingly. The pressure is
correct when the workpiece is
fed securely and evenly without
feed marks being left on it.
11.08 Inserting the bobbin case
Switch the machine off!
● Open the cover 1 to the hook
compartment.
● Insert the bobbin case 2 into the bobbin
case carrier 3.
● Close the hook compartment with the
cover 1.
To Next Page
Loading...
