Adjustment
14 - 35
14.12.12 Stopping the knife on the double cycle
Requirement
With the engaging cylinder retracted the locking lever 1 must be touching the pin 2 of the
knife latch.
Fig. 14 - 33
2 mm
4
3
7
5
6
8
1
11
2
9
10
0.3 to 0.5 mm
● Bring the machine to its program end position and disengage the stop motion device.
● Loosen nut 3 and wind screw 4 back completely.
● Loosen nut 5 and move stop 6 so that there is a clearance of 2 mm between the swit-
ching lever 7 and lever 8. The stop must be parallel to lever 11.
● Tighten nut 5.
● Wind screw 4 until there is a clearance of 0.3 to 0.5 mm between screw 4 and lever 8.
● Tighten nut 3.
● Engage the stop motion device.
● Press lever 8 against the switching lever 7.
● In this position move the clamp piece 9 so that the locking lever 1 is touching the pin 2 of
the knife latch.
● Tighten screw 10.
● Disengage the stop motion device.
● If necessary, remount the thread tensioning plate.
To Next Page
Loading...
Need help?
General
