Preparation
Fig. 11 - 13
Fig. 11 - 14
11 - 10
1
2
1
11.13 Adjusting the bartack width
● Adjust the bartack width by turning the
milled screw 2.
● Close cover 1.
The bartack width is set
correctly when the bartack
stitches cover both purl seams.
11.12 Adjusting the right purl seam position
● Adjust the right purl seam position by
turning the milled screw 1.
The right purl seam position
must be adjusted in relation to
the left purl seam position so
that the cutting area between
the two seams is adequately
wide.
To Next Page
Loading...
