4 – Introduction
Presser Feet
0A – Standard Presser Foot
(attached to the machine upon delivery)
This foot is used for general sewing on most types of fabric. The bottom of the foot is
at, so that the fabric is held down rmly against the feed teeth while sewing. It also has
a wide slot so that the needle can move from left to right, depending on which stitch you
sew.
2A – Fancy Stitch Foot
When sewing decorative stitches or short zigzag stitches and other utility stitches with
less than 1.0mm stitch length, use this foot. The groove on the underside of the foot is
designed to ow smoothly over the stitches.
3 – Blindhem Foot
This foot is used for blindhem stitches. The toe on the foot guides the fabric. The red
guide on the foot is designed to ride along the fold of the hem edge.
4 – Zipper Foot
This foot can be snapped on either the right or the left of the needle, making it easy to
sew close to both sides of the zipper teeth. Move needle position to right or left to sew
closer to zipper teeth.
One–Step Buttonhole Foot
This foot allows you to make perfectly sized buttonholes for your button. It has a space
at the back for a button, used to set the size of the buttonhole. The machine will auto-
matically sew a buttonhole to t that button size.
Embroidery/Free-Motion Foot
The Embroidery/Free-Motion Foot
is recommended for hoop embroidery.
This foot is also great for free motion sewing when used with a straight stitch and low-
ering the feed teeth. It releases the fabric when the needle is in the up position, allowing
you to move the fabric freely for quilting, monogramming and embroidery.
1/4” quilting foot
This foot is perfect for piecing and patchwork, especially when used in conjunction
with the straight stitch needle plate. The distance from the needle to the outer edge of
the right toe is 1/4” (6mm). The distance from the needle to the inner edge of the
right toe is 1/8” (3mm).
To Next Page
Loading...
