PG Drives Technology SIGMADRIVE Series User Manual

SIGMADRIVE TECHNICAL MANUAL – AC TRACTION PG DRIVES TECHNOLOGY
About this manual
This manual is divided into 10 chapters.
Chapter 1 – Installation
This chapter deals with the mounting, connection and wiring of the Sigmadrive.
Chapter 2 – Adjustments
This chapter deals with the Sigmadrive’s ‘Adjustments’ parameters.
Chapter 3 – Diagnostics
This chapter provides an overview of the diagnostic capabilities of the Sigmadrive range.
Chapter 4 – Controller Set-up
This chapter deals with the Sigmadrive’s ‘Controller Set-up’ parameters.
Chapter 5 – Motor Set-up
This chapter deals with the Sigmadrive’s ‘Motor Set-up’ parameters.
Chapter 6 – Motor Set-up Example
This chapter provides a typical motor set-up guide for the Sigmadrive.
Chapter 7 – Hand-held Programmer
This chapter provides an overview of the Sigmadrive Hand-held Programmer.
Chapter 8 – Calibration
This chapter deals with the Sigmadrive’s ‘Calibration’ parameters.
Chapter 9 – Sigmagauge
This chapter provides an overview of the Sigmagauge.
Chapter 10 – Technical Specifications
This chapter provides a summary of the Sigmadrive’s Technical Specifications.
Icons
Throughout this manual, icons are used to draw the reader’s attention.
The icons used are:
Note – A general point for best practice.
Caution – A point of safety which if ignored could result in damage to the control system or the
vehicle.
Warning – A point of safety which if ignored could cause injury to the individual.
PG Drives Technology accepts no liability for any losses of any kind if these points are not followed.
SK79646-01 6

PG Drives Technology SIGMADRIVE Series Specifications

General

Brand	PG Drives Technology
Model	SIGMADRIVE Series
Category	Controller
Language	English