PG Drives Technology SIGMADRIVE Series - Brake End Speed

To Next Page

To Previous Page

AC TRACTION – MOTOR SET-UP PG DRIVES TECHNOLOGY

1.42 Brake End Speed – (BrkEndSpd)

This sets the speed at which the controller goes into Hill Hold mode. Usually this parameter is set to 0Hz, however, the mass inertia

of the vehicle may sometimes make it desirable to increase this value.

The adjustable range is 0Hz to 5Hz in 0.0625Hz steps.

SK79646-01 64

PG Drives Technology SIGMADRIVE Series - Brake End Speed - (Brkendspd)