c. Check driven spring free
length: standard: 87.9mm
Limit of use:change it as it
Is below 82.5mm(50cc)
d. Check wearing condition of
driving plate set.
Outer diameter measurement:
Limit of use:change it as it
Is above 33.950mm
e. Check wearing condition of
slide driven plate.
Inner diameter measurement:
Limit of use:change it as it
Is above 34.070mm
f. Check is there any wearing
occur to the ditch.
g. Check wearing condition of
seal location, if necessary
change a new one.
To Next Page
Loading...
