Delete a running timer while the receiver is in
standby
A timer is running and your receiver is in standby. Recording
is signalled by two front LEDs,the right-hand one is red and
the left hand one is orange.
- Switch the receiver to running mode.
- Press the key sequence "TIMER,0" to delete the running
timer.The red light then switches off and you can change
channels.
6.10 Using the TV/STB button
This button is used to switch between watching digital
channels through your digital receiver and standard analogue
channels.
While watching digital TV:
- Press the TV/STB button to switch to analogue
TV/VCR/DVD.
- Press again to revert to digital TV.
6.11 Watching locked channels
If you select a locked channel, you are prompted to enter
your PIN code:
- Enter your 4-digit PIN code (default 0000) and press "OK"
to unlock the selected channel and watch it.
6.12 How do I reset my receiver
- Press the "LOW POWER" button on the receiver front
panel for at least 5 seconds.Your Preferences settings will
not be lost.
- Release the button and wait for a stable front display
indication (i.e. the left LED is either orange for standby
mode or green for TV mode).You can then continue with
normal operation.
20 DAY TO DAY OPERATION
English
Doc.DTR2000 version N/B 19/12/03 9:01 Page 20
To Next Page
Loading...
