Philips WACS700 - General Information and Care; Environmental and Safety Information; Cabinet Care and Disc Handling

44
General info
Environmental information
– All redundant packing material has been omitted.We have done our utmost to make the packaging
easily separable into three mono materials: cardboard (box), polystyrene foam (buffer) and
polyethylene (bags, protective foam sheet).
– Your set consists of materials which can be recycled if disassembled by a specialized company.
Please observe the local regulations regarding the disposal of packing materials, exhausted batteries
and old equipment.
Care and safety information
● Avoid high temperatures, moisture, water and dust
– Do not expose the player, batteries or discs to humidity, rain, sand or excessive heat (caused by
heating equipment or direct sunlight.)
● Avoid condensation problem
– The lens may cloud over when the player is suddenly moved from cold to warm surroundings,
taking it impossible to play a disc. Leave the player in the warm environment until the moisture
evaporates.
● Do not block the vents
– Do not operate the DVD Player in an enclosed cabinet, allow about 10 cm (4 inches) of free
space all around the player for adequate ventilation.
● Care of the cabinet
– Use a soft cloth slightly moistened with a mild detergent solution. Do not use a solution
containing alcohol, spirits, ammonia or abrasives.
● Finding a suitable location
– Place the player on a flat, hard, and stable surface.
Disc handling
– To take a disc out of its box easily, press the centre spindle while lifting it. After use, always
take the disc out of the set and store it in the disc case.
–
Never attach a sticker to a disc. If you want to provide a disc with an inscription use a soft felt-
tipped pen and write only on the printed side.
– To clean a disc, wipe it in a straight line from the centre towards the edge using a soft, lint-free
cloth.
– Any cleaning agents may damage the disc!
Setup
– Place the set on a flat, hard and stable surface.
–
Do not position the set on top of other equipment that might heat it up (e.g. receiver or amplifier).
– Place the apparatus in a location with adequate ventilation to prevent internal heat build up.
– Allow at least 10 cm (4 inches) clearance from the rear and the top of the unit and 5 cm (2 inches)
from each side. The apparatus shall not be exposed to dripping or splashing.
– Do not place any sources of danger on the apparatus (e.g. liquid filled objects, lighted candles).
–
Do not block any ventilation openings.