FL MGUARD CENTERPORT
105656_en_05 PHOENIX CONTACT 243
1. Restart/boot the device.
2. As soon as the device boots, press one of the arrow keys on the keyboard several times
until the boot process is interrupted: , , or .
3. The boot menu is displayed.
.
Figure 11-6 FL MGUARD CENTERPORT boot menu
4. Select one of the options to perform the rescue procedure using the arrow keys or :
Start rescue procedure via DHCP / BOOTP+TFTP
OR
Start rescue procedure from CD / DVD, USB stick or SD Card
To apply the selection, press the Enter key.
The options include:
Start rescue procedure via DHCP/BootP+TFTP
Effect: The device downloads the necessary files from the TFTP server:
– install.x86_64.p7s
– firmware.img.x86_64.p7s
Start rescue procedure from CD/DVD, USB stick or SD Card
General requirements:
1. A CD/DVD drive connected to the USB port or
2. A USB stick (USB Flash drive) connected to the USB port or
3. An SD memory card inserted into the SD card drive
After the rescue procedure has been started by pressing the Enter key, the required data is
downloaded from the medium that was connected/inserted to/into the device.
Start rescue procedure from CD/DVD
Requirement: The firmware of the mGuard has been previously burnt to CD/DVD (see
below under “Burning the mGuard firmware to CD/DVD-ROM” on page 245).
Effect: The mGuard device downloads all necessary files from the inserted CD/DVD.
With this in mind, while the boot menu is displayed and before applying this selection,
insert the CD/DVD with the mGuard firmware into the CD/DVD drive.
To Next Page
Loading...
Need help?
General
