Phoenix Contact FL SWITCH LM 8TX-E - Page 65

Configuration and diagnostics
7278_en_04 PHOENIX CONTACT 3-37
Syntax Integer32 (0 - 1024)
Access Read/write
Description This object can be used to set the transmission mode for the relevant port:
Auto negotiation 1
10 Mbps half duplex 2
10 Mbps full duplex 3
100 Mbps half duplex 4
100 Mbps full duplex 5
flWorkNetPortIfIndex
OID 1.3.6.1.4.1.4346.11.11.4.2.2.1.11
Syntax Integer32 (0 - 1024)
Access Read
Description Contains the index of the port according to IEEE 802.3ad.
flWorkNetPortType
OID 1.3.6.1.4.1.4346.11.11.4.2.2.1.13
Syntax Octet string
Access Read
Description Specifies the medium of this port.
flWorkNetPortModuleName
OID 1.3.6.1.4.1.4346.11.11.4.2.2.1.14
Syntax Octet string
Access Read
Description Specifies the "name" of the module.
flWorkNetPortInterfaceName
OID 1.3.6.1.4.1.4346.11.11.4.2.2.1.15
Syntax Octet string
Access Read
Description Specifies the "name" of the interface.
flWorkNetPortStpMode
OID 1.3.6.1.4.1.4346.11.11.4.2.2.1.18
Syntax Integer
Access Read
Description Specifies the port mode during redundancy operation:
Spanning Tree 1
Rapid Spanning Tree 2
Glass fiber FX ports only support operation at 100 Mbps full duplex (5).
The auto crossing function is only active when auto negotiation is enabled. If the
transmission speed or transmission mode is set to a fixed value, the auto crossing
function is disabled.