Configuration and diagnostics
7278_en_04 PHOENIX CONTACT 3-9
Trap Configuration This part of the table is used to view or modify the IP addresses of the two trap receivers. It
is also used to activate/deactivate the "send traps" function.
"Software Update" menu
This page is used to view or modify the parameters for a software update and to trigger the
update.
Figure 3-10 "Software Update" web page
3.2.4 Carrying out the firmware/software update
Requirements
The device must have valid IP parameters so that the firmware can be updated. You also
need a functional Factory Manager or another TFTP server.
Proceed as follows to update the software:
• Save the desired firmware/software in the download directory of your TFTP server. If
you use the Factory Manager, the path for standard installation is as follows:
"C:\Program Files\Phoenix Contact\Factory Manager\Version 2.3\download".
• Start the Factory Manager and check whether the TFTP server is activated.
Figure 3-11 Factory Manager with activated TFTP server
• Start the WBM of the switch and call the "Software Update" page
(...General Configuration/Software Update).
• Enter the IP address of the computer on which the Factory Manager is installed in the
"TFTP Server IP Address" field.
• Then enter the complete file name of the firmware file in the "Downloadable File Name"
field, but do not enter the path (i.e., no drive, no folder).
A suitable version of the Factory Manager can be downloaded at
www.phoenixcontact.com
.
To Next Page
Loading...
