Phonak roger - Other important information; Declaration of Conformity

62 63
X-ray radiation, CT or MRI scans may destroy or
adversely aect the correct functioning of the device.
Do not use excessive force when connecting your
device to its dierent cables.
Protect all openings (audio input and charge) from
dirt and debris.
If the device has been dropped or damaged, if it
overheats, has a damaged cord or plug, or has been
dropped into liquid, stop using your device and
contact your authorized service center.
13.3 Other important information
• Device collects and stores internal technical data. This
data may be read by an authorized service center in
order to check the device, as well as to help you use
your device correctly.
• The digital signal sent from the device to a connected
receiver cannot be overheard by other devices which
are not in the transmitter’s network.
13.4 Declaration of Conformity
In body worn operation, the devices have been found in
compliance with the requirements of EN 62209-2, FCC
rule paragraph 2.1093, the ANSI/IEEE C95.1:1999, the
NCRP Report Number 86 for uncontrolled environment,
according to the Health Canada’s Safety Code 6 and the
Industry Canada Radio Standards Specication RSS-102
for General Population/Uncontrolled exposure.
Hereby, Phonak Communications AG, Laenggasse 17,
CH-3280 Murten, declares that these products are in
compliance with the essential requirements and other
relevant provisions of Directive (2014/53/EU). To obtain a
copy of the Declaration of conformity, please contact the
manufacturer or the local Phonak Communications AG
representative whose address can be taken from the list
on www.phonak-communications.com/ (worldwide
locations).
This device complies with Part 15 of the FCC Rules and
with (RSS-247 and RSS-210) of Industry Canada.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)