PIKO 55821 - Technical Data; PIKO Smartbox; PIKO Smartcontroller; EU- Declaration of Conformity; FCC Notice

System
wlan
50
5. Technical data
a. PIKO SmartBox
wlan
(Command Station 55825)
• Voltage supply: plug-in power supply - input: 100-240 V 50 Hz, output: DC 16 V / 2,25 A
• Max. load main track output: 2 A
• max. load programming track output: 250 mA
• WLAN: 2.4 GHz – 2.483 GHz range, maximum transmission power: 100 mW
• Dimensions: 144 x 96 x 30mm - 7” x 3.8” x 1.2” inches
b. PIKO SmartController
wlan
(hand held throttle 55823)
• High-resolution 40x30mm (1.6”x1.2”) TFT display
• WLAN: 2.4 GHz – 2.483 GHz range, maximum transmission power: 100 mW
• Battery: Lithium Ion 3.7V / 1400mAh
• Dimensions: 189 x 79 x 37mm - 7.4” x 3.1” x 1.5” inches
EU Declaration of Conformity
PIKO Spielwaren GmbH hereby declares that this product complies with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address: https://
www.piko.de/konformant
FCC Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference. (2) This device must accept any
interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment o󰀨 and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit di󰀨erent from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help.
WARNING: Changes or modications not expressly approved by the party responsible for compliance
could void the user‘s authority to operate the equipment.
FCC Radiation Exposure Statement 55823 PIKO SmartController
wlan
The equipment has been evaluated to meet general RF exposure requirement. The device can be used
in portable condition without restriction.
FCC Radiation Exposure Statement 55825 PIKO SmartBox
wlan
This equipment complied with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator &
your body.