Pilz PITreader - Page 50

Operation
Operating Manual PITreader, PITreader Firmware V1.5.x
1004806-EN-08
| 50
} Activated operating mode area
The evaluations are based on the data reported from a safe evaluation unit PITm4SEU.
For this reason, the table is only displayed when a safe evaluation unit is connected to a
base unit.
Evaluations of the operating modes are displayed in the table under Activated operating
mode.
– Operating mode
All operating modes are listed in the column (operating mode 1…5).
– Duration (total)
This column contains the calculated total time for which the operating mode was act-
ive in the device.
-For format of time display see [1]
– Duration (median)
This column contains the time for which the operating mode was active in the device,
calculated from a "median" perspective.
-For format of time display see [1]
-Definition of "Median" see [2]
[1]
Time format: <Day(d) Hour(h) Minute(m) Second(s)>
Examples:
} 1h0m1s
} 1d 0h 20m 5s
[2]
The median of a series of values is the value that is right in the middle, if you sort the val-
ues by size.