1 Display the “Initial Setting” screen.
= For details, refer to Displaying the
“Initial Setting” screen on the previous
page.
2 Turn MULTI-CONTROL to select “S/W
Control”.
3 Press the center of MULTI-CONTROL to
switch between “Rear SP:F.Range” and
“Rear SP:S/W”.
When no subwoofer is connected to the rear
output, select Rear SP:F.Range.
When a subwoofer is connected to the rear
output, select Rear SP:S/W.
p Both rear speaker leads output and RCA
rear output are switched simultaneously in
this setting. (When you use the product
without RCA rear output, this setting only
applies to the rear speaker leads.)
Setting the rear output
1 Display the “Initial Setting” screen.
= For details, refer to Displaying the
“Initial Setting” screen on the previous
page.
2 Turn MULTI-CONTROL to select “Pre-
out”.
3 Press the center of MULTI-CONTROL to
switch between “Subwoofer” and
“Rear”.
Switching the sound
muting/attenuation
You can select the muting method when the
voice guidance is output.
p When you use a cellular phone connected
with Bluetooth technology (dialing, talking,
incoming call), the audio source volume is
always muted independently of this setting.
1 Display the “Initial Setting” screen.
= For details, refer to Displaying the
“Initial Setting” screen on the previous
page.
2 Turn MULTI-CONTROL to select
“Guidance”.
3 Press the center of MULTI-CONTROL re-
peatedly until the desired setting appears
in the display.
Each press of MULTI-CONTROL changes the
settings as follows:
! “ATT”:
The audio source is attenuated automati-
cally when the voice guidance is output.
! “Mute”:
The audio source is muted automatically
when the voice guidance is output.
! “Normal”:
The audio source volume does not change.
p Operation returns to normal when the cor-
respond action is ended.
Customizing the initial settings
En
105
Chapter
26
Customizing the initial settings
To Next Page
Loading...
Need help?
General
