Messages for audio functions
When problems occur in the audio source, a message may appears on the display. Refer to the
table below to identify the problem, then take the suggested corrective action. If the error persists,
contact your dealer or your nearest Pioneer Service Center.
Built-in CD drive
Message Cause Action (Reference)
Error-11, 12, 17, 30 Dirty Clean the disc.
Scratched disc Replace the disc.
Error10, 11, 12, 15, 17, 30, A0,
CHK CDCORE
Electrical or mechanical Turn the ignition switch OFF and back ON, or
switch to a different source, then back to the
CD player.
Error-15 The inserted disc does not contain
any data.
Replace the disc.
Error-23 The CD format cannot be played
back.
Replace the disc.
Error-22 The inserted disc does not contain
any files that can be played back.
Replace the disc.
No Audio The inserted disc does not contain
any files that can be played back.
Replace the disc.
TRK Skipped The inserted disc contains files that
are protected by DRM.
Replace the disc.
Protect All the files on the inserted disc are
secured by DRM.
Replace the disc.
Heat The temperature of the navigation
system is outside of the normal op-
erating range.
Wait until the unit’s temperature returns to
within normal operating limits.
USB/iPod
Message Cause Action (Reference)
No Audio The connected USB storage device
does not contain any files that can
be played back.
Store playable files.
Protect All the files on the inserted external
storage device are secured by DRM.
Store playable files.
TRK Skipped The protected files are skipped. Store playable files.
Check USB The USB connector or USB cable is
short-circuited.
Confirm that the USB connector or USB
cable is not caught in something or da-
maged.
The connected USB storage device
consumes more than 500 mA (maxi-
mum allowable current).
Disconnect the USB storage device and do
not use it. Turn the ignition switch to OFF,
then to ACC or ON and then connect the
compliant USB storage device.
Error-A1 The connected USB storage device
consumes more than 500 mA (maxi-
mum allowable current).
Disconnect the USB storage device and do
not use it. Turn the ignition switch to OFF,
then to ACC or ON and then connect the
compliant USB storage device.
Appendix
En
117
Appendix
Appendix