2 Turn MULTI-CONTROL to select “Loud-
ness”.
3 Press the center of MULTI-CONTROL to
turn loudness on.
Loudness level (e.g., Mid) appears in the dis-
play.
p To turn loudness off, press
MULTI-CONTROL again.
4 Press MULTI-CONTROL left or right to
select a desired level.
Each time MULTI-CONTROL is pressed left or
right, level is selected in the following order:
Low — Mid — High
Using subwoofer output
The navigation system is equipped with a sub-
woofer output mechanism, which can be
turned on or off.
1 Display the “Audio Menu” screen.
= For details, refer to Displaying the
“Audio Menu” screen on page 106.
2 Turn MULTI-CONTROL to select “Sub-
Woofer1”.
3 Press the center of MULTI-CONTROL to
turn subwoofer output on.
p To turn subwoofer output off, press
MULTI-CONTROL again.
4 Press MULTI-CONTROL left or right to
set the phase of subwoofer output.
It changes the settings as follows:
! “Reverse”:
Sets to reverse phase.
! “Normal”:
Sets to normal phase.
5 Turn MULTI-CONTROL to select “Sub-
Woofer2”.
6 Press MULTI-CONTROL left or right to
select cut-off frequency.
Each time MULTI-CONTROL is pressed left or
right, frequencies are selected in the following
order:
50 Hz — 63 Hz — 80 Hz — 100 Hz — 125 Hz
7 Press MULTI-CONTROL up or down to
adjust the output level of the subwoofer.
Each time MULTI-CONTROL is pressed up or
down, subwoofer level increases or decreases.
“+6” to “-24” is displayed as the level is in-
creased or decreased.
Using the high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, activate HPF
(high pass filter). Only frequencies higher than
those in the selected range are output from
the front or rear speakers.
1 Display the “Audio Menu” screen.
= For details, refer to Displaying the
“Audio Menu” screen on page 106.
2 Turn MULTI-CONTROL to select “HPF”.
3 Press the center of MULTI-CONTROL to
turn high pass filter on.
p To turn high pass filter off, press
MULTI-CONTROL again.
4 Press MULTI-CONTROL left or right to
select cut-off frequency.
Each time MULTI-CONTROL is pressed left or
right, frequencies are selected in the following
order:
50 Hz — 63 Hz — 80 Hz — 100 Hz —
125 Hz
Audio adjustments
En
108
Chapter
27
To Next Page
Loading...
Need help?
General
