101
Precaution:
To safely attach the brackets to the support columns, be sure to
always have two people do this task as shown in the drawing.
[Adjusting the angle of the plasma display
screen]
When you want the screen to be easier to see,
you can angle it forwards by altering the bracket
attachment locations. (5°)
4 Attaching a panel to the stand once the bracket has been attached
1. Fix the holes on the protruding portion of the bracket onto the left and right bolts attached to the display stand.
2. Using two hexagonal bored bolts (M8 x 20), fix the bracket to the left and right sides of the display stand by
inserting and screwing in the bolts into the screw holes located at the bottom of the protruding part of the bracket
and the screw holes of the display stand.
3. Screw the bolts of the protruding portion of the bracket firmly into place.
Note: In order to ensure safe installation, always be sure to alternately tighten each bolt two times or more until
they are firmly fixed in place.
5 Attaching the stand shelf to the display stand
Hold the stand shelf at a diagonal to the display stand and insert the upper portion of the hooked end of the shelf
brackets into the slits located on the display stand before then returning the shelf to a horizontal position to fix it into
place (shelf withstand load: 20 kg).
Mobile Cart: PDK-5014
1,3
2
1,3
5°
0°
Display stand
Slits
Hook
Insert the hook securely
into the slit.
[503CMX/503MXE : 433CMX/433MXE]
To Next Page
Loading...
Need help?
General