Pipistrel Sinus - Page 11

K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
Now we have to to drill the holes for the brake pins.
 The goal is to drill a hole that is just deep enough, so that the pin, once placed, sticks out
exactly 1 cm from the brake assembly resting plate. This can be done by marking the
drill.
 Insert the pins and tap them in with a hammer
http://www.pipistrel.si © Pipistrel Release March 2009 © Page 11 of 267