Pipistrel Sinus User Manual

K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
 The brake line for the right pedals gets feed through the floor and through a small hole in
the side of the cavity under the floor. It exits out the long slot on the right hand side of
the cockpit floor. It is important to make sure the lines do not interfere with other cables
under the floor, so run the brake cables on the floor beneath all the other cables and
secure them down with tape and silicone.
 Slide about 350 mm of fuel hose over the right hand brake line to prevent the brake line
from getting worn out. When positioned correctly, add a small dab of Loctite 407 to hold
it in place.
 For the left brake line, fit a rubber grommet and feed it through the hole you drilled in the
middle of the cabin. Apply Loctite 406 to secure it and prevent it from wearing out.
http://www.pipistrel.si © Pipistrel Release March 2009 © Page 112 of 267

Pipistrel Sinus Specifications

General

Manufacturer	Pipistrel
Seats	2
Rate of climb	5.5 m/s (1, 080 ft/min)
Ballistic parachute rescue system	Optional
Engine	Rotax 912
Type	Motor glider