Pipistrel Sinus - Page 183

To Next Page

To Previous Page

K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t

 Between the top hole and each side hole, which you have already marked, there is a need

to mark 4 more drilling points, making for a total of 11 holes. Therefore, divide the

remaining space between the side hole and top hole into 5 sections, each approximately

117-118 mm long.

 Start by drilling a 3mm hole at the top of the upper cowl at the spot you marked. Then

drill one hole on the right side, then the next on the left, then the next on the right and

so on. Make sure you fit temporary screws as you go. Do so until you reach both side

holes and you have a total of 11 holes.

 Now let's drill the holes into the lower cowl. As with the upper cowl, find the centerline

separating the two cowls and measure 20mm downwards along the gap and then

13.4mm towards the spinner. Mark this spot for the first hole.

 From the first hole, measure downwards approx. 125 mm and mark this sport for the

second hole.

 Do the same on the other side of the lower cowl

Other manuals for Pipistrel Sinus