Pipistrel Sinus - Page 236

K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
Preparing the fuselage for the headrests and windscreen:
 The holes for the headrests should be already cut. If not, they will definitely be marked,
so cut the holes for the headrest with a Dremel.
 Cut the hole for the windscreen support in the front of the fuselage. Pay particular
attention to the fact that the material is only 3mm thin and if you cut to close to the edge
damage will result. The hole comes already market on the fuselage.
http://www.pipistrel.si © Pipistrel Release March 2009 © Page 236 of 267