Pipistrel Sinus User Manual

K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
amount of epoxy. The bracket must be left in place for 1 day to allow the epoxy to cure
before it can be drilled and bolted (this will probably be fitted at the factory for safety
reasons)
 Wipe off the extra epoxy
http://www.pipistrel.si © Pipistrel Release March 2009 © Page 80 of 267

Pipistrel Sinus Specifications

General

Manufacturer	Pipistrel
Seats	2
Rate of climb	5.5 m/s (1, 080 ft/min)
Ballistic parachute rescue system	Optional
Engine	Rotax 912
Type	Motor glider