1. Check the level of sealing solution by checking the sight window on the front of the feeder deck.
2. Place the envelopes with the flap side facing down and the top edge against the rear wall.
3. Make sure that the seal/no seal lever is set to the seal position (all the way to the left).
4. Place the envelopes on the feed deck. Tap Start on the Envelope Printing app.
If the moistener tank is full and your envelopes do not seal correctly, clean or replace the moistener
brush and wick.
Sealing envelopes without printing postage
Use Seal Only mode to seal envelopes without printing anything.
8 • Sealing
Pitney Bowes User Guide March 2023 92
To Next Page
Loading...
