Planer BT37 MarkII - Acknowledging an Alarm; Intended Use; Safety; Warnings

13
BT37 MarkII: Service Manual MA200606 1.0.0
Introduction
State Status
indicators
Buzzer External
alarm
Display
Standby Steady orange Off Off Standby
Normal Steady green Off Off Normal display
Unacknowledged
alarm
Flashing red On Off Alarm message
Unacknowledged
alarm for longer than
5 minutes
Flashing red On On Alarm message
Acknowledged alarm Steady red Off Off Normal display
Temperatures not
ready.
Steady orange Off Off Normal display
1.1.6.1 Acknowledging an alarm
When an alarm occurs, an alarm message is shown. An example is shown below:
1. To silence the alarm, press SILENCE.
2. To acknowledge the alarm, press OK. This will close the alarm message.
1.2 Intended use
The BT37 has been designed as a general purpose bench-top incubator. To be used to
provide an environment with controlled temperature at or near body temperature, carbon
dioxide, oxygen and nitrogen gases and elevated humidity.
1.3 Safety
1.3.1
Warnings
 Operating the equipment in a manner not specified within this manual or under
conditions outside of the equipment specifications, may result in the protection offered
by the equipment being impaired.
 Use in well ventilated areas. Risk of asphyxiation from carbon dioxide released from
the equipment. Additional ventilation may be required. Consider carbon dioxide alarms
in confined spaces. Refer to the Gas supply topic for gas release rates.
170