User Manual of WDAP-C7210E_WDAP-W1200E_WDAP-850AC
-63-
5G TX Power The range of transmit power is Max (100%), Efficient (75%),
Enhanced (50%), Standard (25%) or Min (12.5%). In case of
shortening the distance and the coverage of the wireless network,
input a smaller value to reduce the radio transmission power.
Multicast Fast
A part of the 802.11n standard that allows sending multiple frames per
single access to the medium by combining frames together into one
larger frame. It creates the larger frame by combining smaller frames
with the same physical source, destination end points, and traffic class
(QoS) into one large frame with a common MAC header.
Short GI
Guard intervals are used to ensure that distinct transmissions do not
interfere with one another.
Packet Threshold
When the length of a data packet exceeds this value, the router will
send an RTS frame to the destination wireless node, and the latter will
reply with a CTS frame, and thus they are ready to communicate. The
default value is 2346.
RTS Threshold
Enable or Disable RTS/CTS protocol. It can be used in the following
scenarios and used by Stations or Wireless AP.
1) When medium is too noisy or lots of interferences are present. If the
AP/Station cannot get a chance to send a packet, the RTS/CTS
mechanism can be initiated to get the packet sent.
2) In mixed mode, the hidden node problem can be avoided.
The default value is 2347.
Preferred 5G
Enable or Disable to let client connect with 5G first.
Terminal Fast Roam
Enable or Disable 802.11k, 802.11v and 802.11r.
To Next Page
Loading...
Need help?
General
