Planmeca Proline CC - Page 33

Chapter C - HELP & ERROR MESSAGES
Planmeca Proline CC panoramic x-ray C-3
Technical Manual
Er 42
Secondary slot not in the position for the panoramic exposure.
Er 43
Secondary slot not in the position for the cephalometric exposure.
Er 44
The patient positioning mechanism zero point set incorrectly.
Er 45
The soft tissue filter position not calibrated.
Er 50
The temperature of the tube head is too low.
Er 51
Temperature sensor open.
Er 52
mA or kV feedback cable open.
Er 53
Up/down motor does not consume power.
Er 54
Up/down motor consumes too much power.
Er 57
Exposure button activated when the unit is turned on.
Er 60
Generator processor power too low.
Er 61
Processor communication error.
Er 62
Limit sensor power missing.
Er 64
The radiation reaching the AEC sensor is very low or missing completely.
Er 65
The radiation reaching the AEC sensor is too high.
Er 70
Processor communication error.
Er 71
Generator processor program memory failure.
Er 72
Keyboard processor program memory failure.
Er 73
Keyboard processor program error.
Er 74
Keyboard processor operating improperly.
Er 75
Keyboard processor operating improperly.
Er 80
Keyboard processor EEPROM failure.
Er 81
Generator processor EEPROM failure.
Er 82
Keyboard processor configuration error.
Er 83
Generator processor configuration error.
Er 84
Tube power generator time out.
Er 90
Keyboard processor EEPROM not activated.
Er 91
Keyboard processor stack overflow.
Er 99
Error code generation error.
ERROR CODE ERROR MESSAGE EXPLANATION