Chapter A - GENERAL & TECHNICAL DATA
A-2 Planmeca Proline CC panoramic x-ray
Technical Manual
2 MANUAL VERSIONS
PLANMECA pursues a policy of continuous product development. Although every effort is made
to produce up-to-date product documentation this manual should not be regarded as an infallible
guide to current production specifications. Planmeca reserves the right to make changes to spec
-
ifications without prior notice.
NOTE PLEASE NOTE THAT THIS TECHNICAL MANUAL IS VALID FOR SOFTWARE REVISIONS
PK 3.75 OR LATER AND PG 2.25 OR LATER (X-RAYS WITH DIMAX3 PK 5.08 OR LATER
AND PG 5.08 OR LATER). If you find that your X-ray unit doesn’t have some keyboard func-
tions, or its keyboard functions differs from procedures described in this manual, then
either the software must be replaced with at least the above mentioned revision, or you
have to relate to an older version of this manual. The former procedure is recommended.
To Next Page
Loading...