2
The manufacturer, assembler, and importer are responsible for the safety,
reliability and performance of the unit only if:
- Installation, calibration, modification and repairs are carried out by
qualified authorized personnel.
- Electrical installations are carried out according to the appropriate
requirements such as IEC364.
- Equipment is used according to the operating instructions
Planmeca pursues a policy of continual product development. Although every
effort is made to produce up-to-date product documentation this publication
should not be regarded as an infallible guide to current specifications. We
reserve the right to make changes without prior notice.
COPYRIGHT PLANMECA USA 2008-03
PUBLICATION Revision 2 JO
Printed copies of this document are considered uncontrolled.
7535.11.Rev001 08.07.2018
To Next Page
Loading...
