6 Installation
6.1 Dimension drawings
The dimension drawings can be found in your technical documentation.
Drawing number Model
9827 891101 PH 55 – 550
Text on drawing Description
INLET Dryer inlet connection
OUTLET Dryer outlet connection
L (for dismantling) Minimal free space to be foreseen for service
purposes
6.2 Installation proposal
General
The dryer is intended for indoor use and should be placed at least under a roof (protected
against sun, wind and rain). The minimum ambient temperature mentioned on the data
plate must be respected. See section Limitations for operation.
Install the dryer on a solid, level floor, suitable for taking its weight.
Make sure to leave enough space (minimum 800 mm (2.6 ft)) around and above the dryer
for servicing purposes. Consult the Dimension drawings.
Provide enough space under the filter elements so that the filter cartridges can be replaced
without having to disassemble the piping.
Make sure that all pipes, filters, valves, etc. are clean and that they are installed correctly
with or without bypass system.
Make sure that the piping is installed stress free.
For more information concerning air nets, cooling systems, etc. refer to the compressor
installation manual.
Instructions
To ensure correct operation, the dryer must be fitted properly into the compressed air circuit,
consisting of the compressor, the dryer and the application.
• Water separator (3) : A high-efficiency water separator removes 90 % of the free water in
the compressed air. If not mounted in the compressor, a water separator needs to be
installed between the compressor and the air receiver or the dryer inlet filter (whichever
comes first).
• It is recommended to install a general purpose inlet filter upstream of the dryer to remove
liquid oil.
A high-efficiency filter (4) (delivered with the dryer (5)) removes particles from the
compressed air down to 0.01 micron and removes the remaining oil (maximum oil carry-over
of 0.01 ppm).
Instruction book
72 2920 7111 23
To Next Page
Loading...
