Getting Started with Your Phone
1 - 9
• Audio connectors and ports on the Multi-Interface Module—to connect
wireless (lapel) microphones, speakers, and recording devices and
computers (to record phone calls).
To connect audio components to the Multi-Interface Module, see your
system administrator.
After you connect an auxiliary audio component to the Multi-Interface
Module, you must enable the component. To enable the component, see
Enabling Auxiliary Audio Components on page 2-13.
2.5mm Audio Connector on Phone
Your conference phone has a 2.5mm audio connector to connect to a mobile
phone or to a computer calling application. You connect a mobile phone so
you can use the conference phone speaker to hear mobile phone calls. You
connect a computer to stream two-way audio from computer calling
applications for hands-free conversations. The 2.5mm audio connector is
located on the right side of your conference phone, behind a door you flip
open.
The following figure shows the 2.5mm audio connector behind the door on the
side of the conference phone. The 2.5mm audio connector has a mobile phone
icon above it.
Note
You do not have to enable audio from a mobile phone or from a computer calling
application. This audio is automatically enabled when you connect the
Mobile Phone Cable or the Computer Calling Cable to the 2.5mm audio connector
on your conference phone.
www.InternetVoipPhone.co.uk | sales@internetvoipphone.co.uk | 0800 088 4846
To Next Page
Loading...
Need help?
General
