Polycom Trio Visual+

Network
Polycom, Inc. 124
audio-only calls are available. Note that Polycom Trio 8800 system does not support Wi-Fi captive portals
or Wireless Display (WiDi).
The Polycom Trio 8800 system supports the following wireless modes:
● 2.4 GHz / 5 GHz operation
● IEEE 802.11a radio transmission standard
● IEEE 802.11b radio transmission standard
● IEEE 802.11g radio transmission standard
● IEEE 802.11n radio transmission standard
Enable Wi-Fi on the Polycom Trio 8800 System
You can wirelessly connect the Polycom Trio 8800 to your network using Wi-Fi, which is disabled by default.
When you enable Wi-Fi, the system reboots.
To enable Wi-Fi from the Polycom Trio 8800:
1 Go to Settings > Advanced > Administration Settings > Network Configuration > Network
Interfaces > Wi-Fi Menu, and turn Wi-Fi On.
The phone restarts.
2 When the phone completes restart, go to Settings > Advanced > Administration Settings >
Network Configuration > Network Interfaces > Wi-Fi Menu to view available networks.
3 Select a network you want to connect to and press Connect.
Configuring Wi-Fi
The parameters you configure depend on the security mode of your organization and whether or not you
enable DHCP. Polycom Trio 8800 system is shipped with a security-restrictive worldwide safe Wi-Fi country
code setting.
The Polycom Trio system supports the following Wi-Fi security modes:
● WEP
● WPA PSK
● WPA2 PSK
● WPA2 Enterprise
Note: When you provision the Polycom Trio 8800 system via Wi-Fi connection to the network, the
Polycom Trio system looks for files on the provisioning server using the LAN MAC address and not
the Wi-Fi MAC address.
Note: You cannot use Polycom Trio Visual+ for video calls when you connect Polycom Trio 8800 to
your network using Wi-Fi. The Polycom Trio 8800 and Polycom Trio Visual+ do not pair when the
Polycom Trio 8800 is connected to your network using Wi-Fi.