i
USER GUIDE
Polycom® VVX® 310 Business Media Phone
Software 4.1.4 | March 2013 | 1725-49089-001 Rev A
Polycom® VVX® 310 Business Media Phone User Guide
24
Ending Conference Calls
To end a conference, and your connection to the other people, press End Call. By default,
when you press End Call, the other two people remain connected. However, your system
administrator may have set up your phone so that all connections end.
To end a conference call:
• From Lines or Calls view, press End Call.
The conference call ends. By default, the other two people remain connected.
Splitting Conference Calls into Two Held Calls
When you split a conference, you end the conference and place the other two people on hold.
You can split an active or held conference call.
To split a conference call:
• From Lines or Calls view, press Split.
The conference call ends. By default, the other two people are held.
Changing the Way Calls are Answered
Change the way calls are answered by doing the following:
• Temporarily refusing all calls by enabling Do Not Disturb.
Using Do Not Disturb
Enabling Do Not Disturb (DND) stops your phone from ringing. All calls you receive while DND
is enabled are logged to your Recent Calls list.
When you enable Do Not Disturb, the following happens:
• The Do Not Disturb icon displays in the status bar, as shown next.
• If your phone is idle, the Do Not Disturb icon, , displays next to your phone line in
Lines view, as shown next. If you have new messages or forwarding enabled, the
messages or forwarding icon will display instead.
To Next Page
Loading...
