2 MAN. PS 254 EN – Ind. 2
LIMITS OF WARRANTY
Original features of the equipment and maintenance
The liability of the Polysoude company for delivered welding equipment is ending
immediately if:
- One or several components have been removed, distorted or altered without permission
in writing from the manufacturer, especially concerning safety facilities, electronic circuit
design or fluid systems...
- The essential maintenance procedures necessary for the faultless operation of the
machine have not been carried out.
Transformation of the original designation of the equipment
If approved equipment is used by the purchaser or a third party as part of a special
machine or an assembly line, instead of an examination part after part the responsible
party has to prove the conformity of the entire unit.
Consequently in this case the liability of Polysoude is released; the purchaser or the third
party has to take the engagements of a builder and to satisfy all applicable legal
requirements.
Stability of the machines
The stability of the machines has to be assured by strictly respecting the handling and
transport procedures specified by Polysoude (refer particularly to the specific chapter in
the Operating and Maintenance Manual).
Handling conditions
To move or displace equipment, the lifting eyebolts or integrated connection rods have to
be used.
In order not to overcharge lifting equipment, the operator must know the weight of the
equipment.
2002 Polysoude
Original edition: Polysoude S. A. Nantes France
All rights reserved. No part of this manual may be reproduced in any form or by any
electronic or mechanical means, including information storage and retrieval systems,
without permission in writing from the publisher, except by a reviewer who may quote
brief passages in a review.
Printed in France.
Published by Polysoude, Nantes, France.
www.polysoude.com info@polysoude.com
To Next Page
Loading...
