Polysoude PS 254 - Modifying the Program Name; Choice of a Built-In Program

24 MAN. PS 254 EN – Ind. 2
3.3. Programming
The titles of the following chapters are:
3.3.1 Entering the program name.
3.3.2 Modifying the program name.
3.3.3 Choice of a built-in program.
3.3.4 Programming and modifying the
welding parameters:
- Configuration.
-Gas.
- Current.
- Rotation.
-Wire.
3.3.5 Programming of sectors:
- Creation of a sector.
- Modification of sector start position.
- Deleting a sector.
3.3.6 Deleting a program from the source
memory.
3.3.7 Entering the time and date.
3.3.8 Entering/modifying the company name.
3.3.9 Saving, loading a program
- Saving a program.
- Loading a program.
3.3.10 Printing a program.
3.3.11 Programmable parameters
Explanation of symbols used
SYMBOL MEANING
Press once to
increase
Press and hold to
increase
Press once to
decrease
Press and hold to
decrease
Press once
Press and hold for
at least 2 seconds
Indicator not
illuminated
Indicator flashing
Indicator
illuminated