MAN. PS 254 EN – Ind. 2 45
3.3.5.2. Modification of sector start
position
During modification, the value of parameter "N"
must be between the values of the preceeding
and the following sector. If this is not the case,
the value will not be accepted.
01-NANTES
S1 V32=200
S2 V3 2=180
S3 V32=180
01-NANTES N=0100 D
S1 V32=200
S2 V3 2=180
S3 V3 2=180
01-NANTES N=0100D
S1 V32=200
S2 V3 2=180
S3 V3 2=180
01-NANTES N=01 3 0D
S1 V32=200
S2 V3 2=180
S3 V3 2=180
01-NANTES N=0130 D
S1 V32=200
S2 V3 2=180
S3 V3 2=180
19
To Next Page
Loading...
