power automation PA 8000 EL User Manual

The Ethernet connector allows connection of the control unit to
local area networks.
Fig. 29: Ethernet connector (RJ 45)
NOTICE!
Malfunctions and damage to the control unit!
The control unit provides one RJ 45 connector. It is
located on the PC interface panel ( Ä “Overview”
on page 49/5) and only intended for Ethernet connec-
tions. Inadvertent interchanging of the connector can
cause control unit malfunctions and damages to the
control unit and the attached drives.
n When setting up the wiring, carefully observe the connectors'
positions given in this installation manual as well as the labels
on the control unit.
Property Value
Pins 8
Connector type RJ 45
Max length 100 m (328 ft)
Pin ( Ä “Ethernet
Connector (5)”
on page 54)
Ethernet 10/100 BaseT
1 TX+
2 TX-
3 RX+
4
5
6 RX-
7
8
Ethernet Connector (5)
PA 8000 EL CNC control unit
Design and function
24.09.2015 | 54

power automation PA 8000 EL Specifications

General

Brand	power automation
Model	PA 8000 EL
Category	Control Unit
Language	English