Chapter 5 Function parameter
29
Show the line speed of DI5 high speed
pulse sampling, according to the actual
sample pulse number per minute and E0.07,
calculate the line speed value.
Total time of current inverter power-on
Total time of current inverter run
HDI(DI5) impulse
frequency
HDI(DI5) High-speed impulse input
frequency display, unit: 1Hz
Frequency, torque or other command values
set by communication port
PG feedback speed, to an accuracy of
0.01Hz
Frequency set by F0.03 master frequency
setting source
Auxiliary frequency
display
Frequency set by F0.04 auxiliary frequency
setting source
Observe the set command torque under the
torque control mode
Synchro rotor position angle
Rotor position when rotary transformer is
used as a speed feedback
Position information calculated from when
ABZ incremental feedback encoder is
adopted
Encoder Z-phase signal count
Display run, standby and other statuses
1.G type (constant torque load type)
2.F type (fans/pumps load type)
AI1 voltage before
correction
Input voltage value before AI1 linear
correction
AI2 voltage before
correction
Input voltage value before AI2 linear
correction
AI3 voltage before
correction
Input voltage value before AI3 linear
correction
motor temperature
inspection function3
PT100 inspect motor temperature value
5-1-2.F0 Group -Basic function group
To Next Page
Loading...
Need help?
General