Ether232Plus User Guide 7 Accessing System Information
02-CML000057 Precidia Technologies Inc. 65
Connection was not from configured
remote address - refused
The incoming connection attempt
was not from the IP address config-
ured as the Remote IP.
Port #n: Connection reset by remote host
at xxx.xxx.xxx.xxx:pppp
The remote host forcibly terminated
the active TCP session with the unit.
Port #n: Connection closed by remote
host at xxx.xxx.xxx.xxx:pppp
The remote host is taking the steps to
correctly close the TCP session with
the unit.
Port #n: Connection closed by us to host
at xxx.xxx.xxx.xxx:pppp
The unit is taking the steps to cor-
rectly close the TCP session with the
remote host.
HTTP: host at xxx.xxx.xxx.xxx failed to
authenticate properly.
The remote host attempted unsuc-
cessfully to access the userid/pass-
word protected HTTP pages.
Internet Explorer may attempt
access using old data from previous
connections, resulting in this error.
Configuration changes saved -- restarting
system
A configuration change was saved.
Unit resets.
Port #n: Listening for connections on tcp
port pppp was not possible (Error #nn)
The unit cannot listen on the speci-
fied port. Table 7.4 lists possible
error codes.
Port #n: Connection attempt to
xxx.xxx.xxx.xxx:pppp was not possible
(Error #nn)
The unit could not connect to the
specified IP address and port num-
ber. Table 7.4 lists possible error
codes.
Port #n: Incoming connection on tcp port
pppp from xxx.xxx.xxx.xxx:pppp (Error
#nn)
The unit could not accept the incom-
ing connection. Table 7.4 lists possi-
ble error codes.
Incoming connection on tcp port held
waiting for connection control
The connection control setting dic-
tates that the incoming connection
not be established until the connec-
tion control signals are matched.
Table 7.3: System Log Messages
Message Description
To Next Page
Loading...