Precidia ipocket232 - Page 84

iPocket232 User Guide Appendix B: Troubleshooting and Support
23-CML000293 iPocket232 Inc. B-6
ETHERNET – TRANSMIT lamp
Flashes when the iPocket232 is sending or receiving data via the Ethernet port.
Normally you will see very short data bursts.
Table B.3: TRANSMIT Lamp Troubleshooting
Lamp
Status
Standard Troubleshooting Procedure
Flashing
OK - data is
being
transmitted
None
Off
No data is
being
transmitted
Ensure the Ethernet cable between the iPocket232
and the Ethernet device is properly connected
SERIAL – TRANSMIT lamp
Illuminates when the iPocket232 is sending or receiving data via the serial port Normally you
will see very short data bursts.
Table B.4: SERIAL TRANSMIT Lamp Troubleshooting
Lamp
Status
Standard Troubleshooting Practice
On
OK - In
configuration
mode
Finish configuring the iPocket232 and exit
from configuration mode.
Flashing
OK - data is
being
transmitted
None
Off
No data is
being
transmitted
• Ensure the serial cable between the
iPocket232 and the serial device is properly
connected
• Was the configuration recently changed?
Look at the System Status page to check the
system uptime. If it is a short period, check
the configuration of the unit to see if it has
been modified recently. Refer to Sections 3
and 4 for further information.