Precidia ipocket232 - Page 98

iPocket232 User Guide Appendix F: MCC
23-CML000293 iPocket232 Inc. F-6
Table F.2: Extended AT& and AT+ Commands
Command
Syntax
Description
Parameters
&F
LOAD FACTORY SETTINGS
Loads the default settings for commands and
S- registers.
none
&Hn
FLOW CONTROL
Sets the type of flow control used. The default
is set in configuration.
n = 0 disables flow control n
= 1 selects hardware (CTS/
RTS) flow control
n = 2 selects software (XON/
XFF) flow control
&Sn
DSR CONTROL Sets how the modem
drives the DSR signal.
n = 0 (or no option present) sets
the DSR line as always
active (default)
n = 1 sets the DSR line to follow
the connection status
&V
VIEW PROFILE SETTINGS Displays the
command and S-register settings.
none
&W
SAVE CONFIG
Writes the current configuration settings into
memory. Includes the S-register values,
command options, IP addresses and port
numbers.
none
&Z?
DISPLAY NUMBERS
Returns the currently configured Remote IP
and Remote Port as “Stored Host #1:
xxx.xxx.xxx.xxx:pppp” and the Fallback IP
and Fallback Port as “Stored Host #2:
xxx.xxx.xxx.xxx:pppp”.
none
&Zn=s
STORE NUMBER
Stores an IP address and port number (in the
form xxx.xxx.xxx.xxx:pppp) into either the
Remote IP and Port or Fallback IP and Port
locations.
n = 0 Stores as Remote IP and Port
(primary location) n = 1
Stores as Fallback IP and Port