119
Replacing the Gripper Spring or Cable
Tools Required:
1. 1.3mm hex driver
2. 2.5mm hex driver
3. 7mm open end wrench
4. Loctite 222
Spare Parts Required: Spring or Cable Assembly
To replace the spring or cable the user must:
1. Remove the Gripper Cover by removing 4 or 6 M2 X 6mm FHCS (depends on model).
2. Remove the spring cab le assembly by removing the M3 screws shown below.
3. Replace the spring cable assembly and replace the cover.
To Next Page
Loading...
