Model PD6000 Analog Input Process Meter Instruction Manual
5
Control Menu (Contrl) -------------------------------------------------------- 30
Setting Up the Meter (setup) ------------------------------------------------ 31
Setting the Input Signal (input) ------------------------------------------ 32
Setting the Decimal Point (dEc pt) -------------------------------------- 32
Setting the Display Parameter & Intensity (dsplay) ----------------- 32
Programming the Meter (prog) --------------------------------------------- 35
Multi-Point Calibration & Scaling ----------------------------------------- 35
Multi-Point Linearization Utility -------------------------------------------- 35
Scaling the Meter (SCALE) -------------------------------------------------- 36
Calibrating the Meter with External Source (Cal) -------------------- 38
Setting the Relay Operation (relay) ------------------------------------- 39
Setting the Relay Action ---------------------------------------------------- 40
Programming Set and Reset Points ------------------------------------- 41
Setting Fail-Safe Operation ------------------------------------------------ 41
Programming Time Delay -------------------------------------------------- 41
Relay Action for Loss of 4-20 mA Input (Loop Break) --------------- 41
Relay and Alarm Operation Diagrams ----------------------------------- 42
High Alarm Operation (Set > Reset) ------------------------------------- 42
Low Alarm Operation (Set < Reset) -------------------------------------- 43
High Alarm with Fail-Safe Operation (Set > Reset) ------------------ 44
Low Alarm with Fail-Safe Operation (Set < Reset) ------------------- 45
Pump Alternation Control Operation ------------------------------------- 46
Relay Sampling Operation ------------------------------------------------- 47
Signal Loss or Loop Break Relay Operation --------------------------- 48
Time Delay Operation ------------------------------------------------------- 49
Relay Operation Details ------------------------------------------------------ 50
Overview ------------------------------------------------------------------------ 50
Relays Auto Initialization ---------------------------------------------------- 50
Fail-Safe Operation ---------------------------------------------------------- 50
Front Panel LEDs ------------------------------------------------------------- 51
Latching and Non-Latching Relay Operation -------------------------- 51
Non-Latching Relay (Auto) ------------------------------------------------- 52
Non-Latching Relay (A-man) -------------------------------------------- 52
Latching Relay (LatcH) ----------------------------------------------------- 52
Latching Relay (Lt-Clr) ---------------------------------------------------- 53
Acknowledging Relays ------------------------------------------------------ 53
Pump Alternation Control Applications (Altern) --------------------- 54
Scaling the 4-20 mA Analog Output (Aout) ---------------------------- 57
Setting Up the Password (pass) ------------------------------------------- 58
Protecting or Locking the Meter ------------------------------------------- 58
Making Changes to a Password Protected Meter -------------------- 59
To Next Page
Loading...
