© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
5 Tighten the generator mounting bolts.
6 Select the QUICKSTART program and adjust the resistance key until
resistance level 10 is displayed. Pedal the AMT for approximately
one minute, then recheck the belt tension.
7 The tension should read approximately 85 ±5 lbs.
Figure 53: Generator
Inspecting and Adjusting the Drive Input Belt Tension
WARNING: Before continuing with this procedure, review the Warning and
Caution statements listed in the Warning and Caution Statements and
General Safety Guidelines Section, Things You Should Know.
Procedure
1 Remove the gasket, top, front, rear, left and right side covers per,
Cover Replacement (on page 152) Procedure .
2 Place a belt gauge to the drive input belt as shown below.
To Next Page
Loading...
