© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Belt Guard Installation
16 Place the two halves of the belt guard so they are positioned around
the flat belt just below the upper arm. The smaller half should be
positioned so that the interlocking tabs are pointing toward the
front of the machine, and the guard toward the back. The larger half
should be positioned with the guard toward the front. Align the
interlocking tabs of the smaller half with the slots of the larger
half; rotate the halves together around the flat belt until the
locking tabs are locked.
Figure 107: Belt Guard Interlocking Tabs and Slots
17 Grasp each belt guard mounting ring, lift the belt guard into
position over the upper arm mounting bolts, and then secure each
mounting ring to the connection ring.
To Next Page
Loading...
