taken to not damage the cables when setting the cross member to the side.
11. Remove the frame cross member four 6 mm hex key bolts (4x) and washers (4x) and
remove the cross member. Remove the generator belt from the generator pulley and
then carefully set the cross member to the side taking care to not damage the cables
12. Remove the flywheel (weight: 26 lbs (12 kgs)) by carefully sliding it rearward off the
frame axle brackets.
WARNING:Personal injury is possible while removing/installing the flywheel. The
flywheel weighs approximately 26 lbs (12 kgs) and can pinch or fall onto fingers or
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 89
5 Replacement Procedures
Drive Belt, Generator Belt, and Flywheel Replacement
To Next Page
Loading...
Need help?
General
