516514 1
Table of Contents
Section 1 – Safety Information
Locating an Authorized Servicer ............................4
Section 2 – Introduction
Customer Service ....................................................5
Nameplate Location ................................................5
Model Identification ................................................6
How Your Dryer Works ..........................................8
Section 3 – Troubleshooting
1. Motor Does Not Run ........................................9
2. Unit Stops In Cycle; Quits After The First Few
Loads; Has a Burning Smell; Cycles On Motor
Thermal Protector .........................................10
3. Motor Runs But Cylinder Does Not Turn ......11
4. Motor Does Not Stop .....................................11
5. Heating Assembly Does Not Heat Or Burner
Does Not Ignite ..............................................12
6. Igniter Does Not Glow (Gas Supply Sufficient)
– Gas Models .................................................13
7. Burner Ignites and Goes Out Repeatedly – Gas
Models ............................................................13
8. Igniter Glows But Burner Does Not Ignite – Gas
Models ............................................................13
9. Heater Assembly or Burner Shuts Off
Prematurely ....................................................14
10. Heater Assembly or Burner Repeatedly Cycles
Off On Limit Thermostat ...............................14
11. Heater Assembly or Burner
Does Not Shut Off ..........................................15
12. Clothes Do Not Dry .......................................15
13. Clothes Are Too Hot When Removed
From Dryer .....................................................16
14. Ignition Control Flashes .................................17
Section 4 – Grounding
15. Ground Wires From Terminal Block or Power
Cord To Rear Bulkhead and From Rear
Bulkhead To Control Housing .......................19
16. Metered and Nonmetered Models – Ground
Wires From Rear Bulkhead To Accumulator
Bracket or Timer (Depending On Model) and
From Cabinet Top To Control Panel ..............20
17. Ground Wires From Rear Bulkhead To Timer
Mounting Bracket and To Dryer Cabinet Top.
Ground Wires From Timer Mounting Bracket
To Graphic Panel ...........................................21
18. Ground Wires From Dryer Base To Wire
Harness and To Ignition Control
(Gas Models With Silicon nITRIDE Ignition
System) ..........................................................21
Section 5 – Service Procedures
19. Access Panel ..................................................23
20. Control Panel and Controls (Metered and
Nonmetered) ..................................................23
To Test Push-to-Start Switch..........................23
21. Graphic Overlay .............................................25
To Test Fabric Selector Switch.......................25
22. Timer (Nonmetered Models) .........................26
To Test Timer Contacts
(Nonmetered Models) .....................................26
23. Accumulator (Metered Models) .....................28
To Test Accumulator (Metered Models) ........29
24. Electronic Control ..........................................30
25. Coin Drop ......................................................32
26. Meter Case (Metered Models) .......................37
27. Timer Case (Nonmetered Models) ................39
28. Security Case and Card Reader .....................40
29. Control Hood .................................................43
30. Cabinet Top (Nonmetered Models) ...............43
31. Cabinet Top (Metered Models) ......................44
32. Lint Filter .......................................................45
33. Loading Door and Door Hinge ......................45
Reversing Door Procedure . . . ..............................46
34. Inner and Outer Door Panels And Door Pull .47
35. Door Strike .....................................................47
36. Door Seal .......................................................48
37. Front Panel and Panel Seal ............................49
38. Door Switch ...................................................49
To Test Door Switch.......................................49
39. Door Catch .....................................................49
40. Door Hinges ...................................................51
41. Hold-down Clips And Locators .....................51
42. Burner System Components (Gas Models) ...52
To Test Gas Valve Coils (Gas Models) ..........54
To Test Igniter (Gas Models)..........................55
Ignition Control Grounding Check .................55
To Test Electrical Circuit to Ignition System
(Gas Models)...................................................55
To Test Sensor (Gas Models) .........................55
To Next Page
Loading...
