62 PRODIGIT
BATT TIME: setting the BATT TIME, the Left 5 digit monitor display the
“BATT” ,the right upper 5 digit monitor display the “TIME”, and right lower monitor
display setting value, the unit is "S". The range is 1s to the 99999s.
BATT Vth: Setting BATT threshold voltage; the Left 5 digit monitor display the
“BATT” ,the right upper 5 digit monitor display the “VTH”, and right lower monitor
display setting value, the unit is "V". The range is 0.01V to the full scale of the
Voltage specification.
• Press the Item key to enter the Item setting mode BATT PRESS START, the LED
Indicators is ON, and then press the setting key. The LED indicator is ON. To exit the
setting, press the EXIT key and select CR MODE. The setting sequence is as follows:
BATT PRESS START
BATT MODE CR
BATT LIN
BATT TIME
BATT VTH
BATT CR : setting the BATT CR, the Left 5 digit monitor display the “BATT” ,the
right upper 5 digit monitor display the “CR”, and right lower monitor display setting
value, the unit is "Ω". The range is 1.6Ωto the full scale of the CR mode
specification.
To Next Page
Loading...
Need help?
General