PROEL MS 32 - Write Global Parameter

14
Proel MS 32 Owner's Manual
WRITE GLOBAL PARAMETER:
Press and release the "SELECT/CHANNEL" switch ( Æ
Æ
) to confirm the data and exit from
"GLOBAL" parameter programming; the display will show the following message:
When using the WRITE switch the display will show the following message:
and will go back to the PATCH MASTER screen shot after some seconds:
W
riteGlobal? W/S
Keep the WRITE/MODE switch ( Æ
Æ
)
pressed to store the GLOBAL parameters.
Press the START/STOP switch (  Æ
Æ
) to
exit without storing the GLOBAL
parameters; the data of the previous
parameters will be lost.
W
riteGlobal? W/S
W
rite Complete !
0 *FACTORY0* >0